12
Bluetooth
®
OPERATION
12-11
D Connection
This section describes how to connect to the
transceiver from an Android device.
Step 1. Preparing for the connection (Transceiver)
Function > CI-V > CI-V Transceive
Set “CI-V Transceive” to ON to control the transceiver
and the RS-MS1A with CI-V commands.
Step 2. Starting the RS-MS1A (Android device)
Tap the RS-MS1A to start.
L See page 12-8 for details on downloading the RS-MS1A.
RS-MS1A icon
Step 3. Connecting to the transceiver
(Android device)
Tap the UT-137
Bluetooth
®
unit name displayed on the
RS-MS1A.
• Starts to connect.
L When your call sign has not been entered in the
transceiver, you should enter in before you connect.
L After the connection has succeeded, the transceiver
displays “MMM Connected,” and the Bluetooth icon is
displayed.
Displayed
L On the PAIRING/CONNECT screen, “ ” is displayed to
the left of the Android device name.
Data device icon
Device name
Displayed while connecting
NOTE: If you cannot connect, check that the same
CI-V address is set between the transceiver and the
RS-MS1A.
You can see the CI-V setting as described below:
Transceiver
“CI-V Address” in the Menu screen.
(Function > CI-V > CI-V Address) (Default: 9A)
RS-MS1A:
“Application Setting” “CI-V setting”
(Default: Transceiver[9A])
TIP: To connect to the Android device from the
transceiver:
When the RS-MS1A is started on the Android
device, you can connect to the device from the
transceiver.
Bluetooth Set > Pairing/Connect
1. Push [MENU].
2. Rotate [DIAL] to select “Bluetooth Set,” then
push [ï].
3. Select “Pairing/Connect,” then push [ï].
4. Select the Android device name displayed in the
pairing list, then push [ï].
5. Select <YES>, then push [ï].
• Displays “MMM Connecting...”
( “MMM” is the Bluetooth name of the Android
device.)
L “ ” is displayed to the left of the Android device
name.
Connecting to an Android™ device (Continued)
To Next Page
Loading...
