3
PRIORITY WATCH
3-7
Step 1. Set the Priority channel
To set the VFO frequency
(See Basic manual section 3)
1. Push [V/M] several times until you enter the VFO
mode.
2. Set the receive frequency and mode you want to
monitor.
To select a Memory channel (p. 1-4)
1. Push [V/M] several times until you enter the
Memory mode.
2. Rotate [DIAL] to select the Memory channel you
want to monitor.
To select a Bank channel (p. 1-9)
1. Push [V/M] several times until you enter the
Memory mode.
2. Push [QUICK].
3. Rotate [DIAL] to select “Bank Select,” then push
[ï].
4. Rotate [DIAL] to select the Bank channel you want
to monitor.
To select a Call channel (p. 1-4)
1. Hold down [CALL] for 1 second to enter the Call
channel mode.
2. Rotate [DIAL] to select the Call channel you want
to monitor.
Step 2. Select the repeater or simplex frequency in
the DR screen (p. 4-3, D-STAR guide)
1. Hold down [DR] for 1 second to display the DR
screen.
2. Select “FROM,” then push [ï].
• Displays the FROM SELECT screen.
L On the DR screen, pushing [DR] toggles between
“FROM” and “TO.”
3. Rotate [DIAL] to select a repeater or a simplex
frequency.
Step 3. Starts the Priority watch (p. 3-2)
1. Push [QUICK].
2. Rotate [DIAL] to select “PRIO Watch,” then push [ï].
3. Select the Priority watch option, then push [ï].
• “P” is displayed, and the Priority watch starts.
Checks the selected Priority channel every 5 seconds,
while receiving a repeater or simplex frequency in
“FROM” of the DR screen.
Scanning “FROM” on the DR screen and a Priority channel
Receiving
(5 seconds)
(Frequency/
Channel)
Priority
channel
“From”
(DR screen)
D When a signal is received
When “ON” is selected.
When a signal is received on the Priority channel, the
channel is automatically selected.
• The “P” icon blinks.
L The scan pause timer and resume settings are the same
as those for a normal scan. (p. 9-18)
Automatically selects the Priority channel.
When “Bell” is selected.
When a signal is received on the Priority channel, the
display remains on the DR screen.
• A beep sounds and the “S” icon blinks.
Remains on the DR screen.
Example: Checks
Memory channel “002”
every 5
seconds while receiving on a repeater
frequency.
Checks Memory channel “002”
every 5 seconds.
Step 4. Canceling the Priority watch (p. 3-2)
1. Push [QUICK].
2. Rotate [DIAL] to select “PRIO Watch OFF,” then
push [ï].
• “P” disappears, and the Priority watch is canceled.
To Next Page
Loading...
