Icom ID-4100A

9
MENU SCREEN
9-12
Menu items and Default settings (Continued)
Display Unit
Latitude/Longitude ddd°mm.mm' or ddd°mm'ss" Selects position format to display the position.
Altitude/Distance m or ft/ml* Selects the units to display the distance and
altitude.
Speed km/h, mph*, or knots Selects the units to display the speed.
Temperature
ç or
ƒ*
Selects the units to display the temperature.
Barometric hPa, mb, mmHg, or inHg* Selects the units to display the barometric
pressure.
Rainfall mm or inch* Selects the units to display the rainfall.
Wind Speed m/s, mph*, or knots Selects the units to display the wind speed.
Display Language English or Japanese Selects the display language in the DR
screen or MENU screen. When “English” is
selected in “System Language,” this item is
not displayed.
System Language English or Japanese Selects English or Japanese as the system
language of the transceiver.
Sounds Sets the Sound options.
Beep Level 0~9 Sets the beep output level.
Key-Touch Beep OFF or ON Turns the conrmation beep tones ON or OFF
when key is pushed.
Home CH Beep OFF or ON Turns the Home CH Beep ON or OFF.
Band Edge Beep OFF or ON Turns the Band Edge Beep ON or OFF.
Scan Stop Beep OFF or ON Turns the Scan Stop Beep ON or OFF.
Standby Beep OFF, ON, ON (to me:High Tone),
or ON (to me:Alarm/High Tone)
Turns the Standby Beep function in the DV
mode ON or OFF.
Scope AF Output OFF or ON Selects the audio output option during a
sweep.
Time Set Sets the Time options.
Date/Time
DATE 2000/01/01~2099/12/31 Sets the current date.
TIME 0:00~23:59 Sets the current time.
GPS Time Correct OFF or Auto Sets to automatically correct the time using a
GPS signal.
UTC Offset –14:00~±0:00~+14:00 Enters the time difference between UTC and
the local time.
Auto Power OFF OFF, 30min, 60min, 90min, or
120min
Turns the Auto power OFF function ON or
OFF.
DV Gateway Enters the Terminal mode or Access Point mode.
<<Terminal Mode>> Enters the Terminal mode.
<<Access Point Mode>> Enters the Access Point mode.
NOTE: The default settings shown in bold letters below are for the USA version.
The default settings may differ, depending on your transceiver version.
*
The default value may differ, depending on the transceiver version.
Previous view