Icom ID-4100A

10
OTHER FUNCTIONS
10-15
Step 2. Remove the microSD card from the master
transceiver, then insert it into the sub
transceiver.
1. Hold down the master transceiver’s [
] to turn
OFF the power.
2. Remove the microSD card from the master
transceiver.
3. Insert the microSD card into the sub transceiver,
then hold down the sub transceiver’s [ ] to turn
ON the power.
NOTE: Before inserting, be sure to check the card
direction. If the card is forcibly or inversely inserted,
it will damage the card and/or the slot.
Master
Sub
TIP: The setting data are saved in the “icf” le format
that is used in the CS-4100 cloning software.
When the saved data on a card is copied to a PC,
you can edit it with the cloning software.
Cloning function (Continued)
D Transceiver-to-Transceiver cloning using a microSD card
This section describes the cloning method using a
microSD card. Memory channel contents, MENU
item settings and repeater lists can be saved onto the
microSD card.
L Recorded voice memories are not included in the
cloning data. To play back the master transceiver’s voice
memory, insert the microSD card into a sub transceiver,
or make a copy onto the sub transceiver’s microSD card
using a PC.
L Assumes that the microSD card has already been
inserted into the transceiver.
Step 1. Saving the master transceiver’s setting
data onto the microSD card.
SD Card > Save Setting
1. Push [MENU].
2. Rotate [DIAL] to select “SD Card,” then push [ï].
3. Select “Save Setting,” then push [ï].
4. Select “<<New File>>,” then push [ï].
• Displays the FILE NAME screen.
L The le name is automatically named in the following
manner: Setyyyymmdd_xx (yyyy: Year, mm: month,
dd: day, xx: serial number)
Example: If a second le is saved on April 1, 2017,
the le is named “Set20170401_02.”
L To change the le name, see “Save with a different
le name.” (p. 6-4)
5. Push [ï].
• The conrmation dialog “Save le?” is displayed.
6. Select <YES>, then push [ï].
• Saves the data settings.
L While saving, a progress bar is displayed, then
returns to the SD CARD screen after the saving is
completed.
7. Push [MENU].
• Returns to the standby screen.
Previous view