Icom ID-4100A

1
MEMORY OPERATION
1-9
D Directly writing into a memory bank
You can also write the memory content directly into
a memory bank channel. This way is a short cut to
creating a memory channel, and then assigning it to
a bank. In that case, the transceiver automatically
selects the lowest blank memory channel, to write.
Example: Writing 146.030 MHz into Bank A.
1. Push [V/M] several times until you enter the VFO
mode.
2.
Rotate [DIAL] to set 146.030 MHz.
3.
Push [MW].
4. Rotate [DIAL] to select “Write to New CH,” then
push [ï].
• Displays the WRITE screen.
5. Push [QUICK].
6. Select a bank, then push [ï].
7. Push [MW].
• The conrmation dialog “Write to a blank channel?” is
displayed.
8. Select <YES>, then push [ï].
• Beeps sound, and writes the memory content to the
bank channel.
TIP: On the WRITE screen, you can select other
channel by rotating [DIAL].
L If you select a pre-entered channel, the previous
channel content will be overwritten.
Memory bank setting (Continued)
D Selecting the Memory Bank mode
When you select the Memory Bank mode, rotating
[DIAL] selects only the entered bank channels in the
selected bank.
1. Push [V/M] several times until you enter the
Memory mode.
2. Push [QUICK].
3. Rotate [DIAL] to select “Bank Select,” then push
[ï].
4. Select a bank, then push [ï].
5. Rotate [DIAL] to select a bank channel.
L Only assigned bank channels are selectable.
L To return to the Memory mode, select “OFF” in step
4.
TIP: After step 5, you can write the displayed content
to the bank channel.
1. After step 5, push [V/M] to enter the VFO mode.
2. Set the frequency, then push [MW].
3. Rotate [DIAL] to select “Write to New CH,” then
push [ï].
[DIAL]
[ ]
[V/M] [MW] [QUICK]
Previous view