Icom ID-4100A

4
D-STAR OPERATION
4-32
You can save repeater information for quick and
simple communication in up to 1500 repeater memory
channels (Repeater list) in up to 50 Groups.
Entering data into the repeater list is required to use
the DR function.
You can enter four types of frequencies into the
repeater list, as shown below:
• DV repeater
• DV simplex
• FM repeater
• FM simplex
D Repeater list contents
The following contents are included in the repeater
list:
• TYPE: Frequency type (p. 4-34)
• NAME: Repeater name (p. 4-34)
• SUB NAME: Repeater sub name (p. 4-34)
• CALL SIGN: Repeater call sign and port letter
(p. 4-34)
• GW CALL SIGN: Gateway repeater’s call sign and
port “G” (p. 4-34)
• GROUP: Repeater group (p. 4-35)
• USE(FROM): Access repeater use (p. 4-35)
• FREQUENCY: Access repeater’s frequency
(p. 4-35)
• DUP: Duplex direction (p. 4-35)
• OFFSET FREQ: Frequency offset (p. 4-35)
• MODE: Operating mode (p. 4-35)
• TONE: Tone setting (p. 4-35)
• REPEATER TONE: Repeater tone (p. 4-35)
• POSITION: Position data accuracy level
(p. 4-36)
• LATITUDE: Latitude of the repeater (p. 4-36)
• LONGITUDE: Longitude of the repeater
(p. 4-36)
• UTC OFFSET: UTC Offset (p. 4-36)
Example: “Hamacho” repeater information
TIP:
• For easy operation, the repeater list is preloaded
into your transceiver. However, if you do an All
Reset, the CPU clears all the setting data, the
memory channels, and the repeater list. We
recommend that you back up the memory data to
a microSD card or save it to a PC using the CS-
4100 cloning software.
• The repeater list can be downloaded from the Icom
website.
http://www.icom.co.jp/world/support/download/rm/
index.html
Repeater list
Previous view