Icom ID-4100A

10
OTHER FUNCTIONS
10-5
The Voice TX function transmits the audio that is on
the microSD card, one time or repeatedly, for up to 10
minutes at the specied interval.
Up to 4 memories can be used for repeatedly calling
CQ or for other events.
When the key function [Voice TX (T1)] is assigned to
a microphone key, push the key to transmit the saved
audio in the “T1” (Voice memory number for TX).
(p. 9-59)
NOTE: Be sure to insert a microSD card into the
transceiver.
Voice TX function
D Recording the voice audio
Voice TX > Record
1. Push [MENU].
2. Rotate [DIAL] to select “Voice TX,” then push [ï].
3. Select “Record,” then push [ï].
• Displays the VOICE TX RECORD screen.
4. Select the memory number, “T1” ~ “T4.”
• The “VOICE TX RECORD (T1)” screen is displayed
when “T1” memory is selected.
5. Push [MW] to start recording.
Audio
level
Displayed
while
recording
Recording
time
L Hold the microphone 5 to 10 cm (2 to 4 inches) from
your mouth, then speak at a normal voice level.
L The maximum record time is 1 minute.
6. Push [MONI] to stop recording.
7.
Push [RX→CS] to playback the recorded audio.
L If you push [MW], the recording starts again. In this
case, the previous recorded audio will be overwritten.
L Push [MODE] to display the microphone gain setting
screen. Rotate [DIAL] to set the gain level.
8. Push [].
• Returns to the VOICE TX RECORD screen.
[]
Cancels
[MONI]
Stops recording
[MW]
Starts to record
[RX→CS]
Playback
[MODE]
Sets the mic gain
[QUICK]
Deletes the le
TIP: On the VOICE TX RECORD screen, push
[QUICK], then select “Clear” to clear the recorded
audio.
Previous view