5
GPS OPERATION
5-38
In the DV mode, this function automatically transmits
the GPS receiver’s current position data at a selected
interval, and should only be used in the simplex mode.
L Your own call sign must be entered to activate the
GPS automatic transmission.
L When “GPS TX Mode” is set to “NMEA,” be sure
to set “GPS Select” to “Internal GPS” or “External
GPS.”
When “GPS TX Mode” is set to “D-PRS,” and “TX
Format” is set to “Position” or “Weather,” be sure to
set “GPS Select” to “Internal GPS,” “External GPS,”
or “Manual.”
Otherwise, you cannot use this function.
(GPS > GPS Set > GPS Select) (p. 9-24)
GPS > GPS Logger > GPS Auto TX
1. Push [MENU].
2. Rotate [DIAL] to select “GPS,” then push [ï].
3. Select “GPS Auto TX,” then push [ï].
4. Select the position data transmit interval.
• Options: Set to between OFF, 5, 10, 30 seconds,
or 1, 3, 5, 10, and 30 minutes.
(Default: OFF)
InformationL
• Selecting “OFF” cancels the GPS automatic
transmission.
• If four GPS sentences are selected in “GPS
Sentence,” “5sec” cannot be selected.
• The GPS message is also transmitted, if entered.
5. Push [MENU].
• Returns to the standby screen.
D Setting the GPS automatic transmission
NOTE:
• Use GPS automatic transmission in only the
simplex mode.
• GPS automatic transmission through a repeater
may interfere with other communications.
When a GPS message is entered, the transceiver
transmits it along with the position data. See page
5-26 for the GPS message entry.
GPS Auto transmission for only Simplex
To Next Page
Loading...
