Icom ID-4100A

4
D-STAR OPERATION
4-15
Connecting to a Reector (Continued)
D Unlinking a reector
Before trying to link to another reector, be sure to
unlink the current connected reector.
1. Hold down [DR] for 1 second to display the DR
screen.
2. Select “TO,” then push [ï].
• Displays the TO SELECT screen.
L On the DR screen, pushing [DR] toggles between
“FROM” and “TO.”
3. Rotate [DIAL] to select “Reflector,” then push [ï].
• Displays the REFLECTOR screen.
4. Select “Unlink Reector,” then push [ï].
• Returns to the DR screen, and “Unlink Reector” and
“U” are displayed in “TO.”
5. Hold down [PTT] to unlink the reector.
• Displays while transmitting.
D Reector Echo Testing
You can transmit a short message, and after releasing
[PTT], your message will be played back. It is a
useful check of how well your signal is getting into
the repeater, and you can use it to verify that your
repeater is operating normally.
1. Hold down [DR] for 1 second to display the DR
screen.
2. Select “TO,” then push [ï].
• Displays the TO SELECT screen.
L On the DR screen, pushing [DR] toggles between
“FROM” and “TO.”
3. Rotate [DIAL] to select “Reflector,” then push [ï].
• Displays the REFLECTOR screen.
4. Select “Echo Test,” then push [ï].
• Returns to the DR screen, and “Echo Test” and “E” are
displayed in “TO.”
5. Hold down [PTT] and speak into the microphone.
• Displays while transmitting.
6. Release [PTT] to hear your message.
Previous view