9
MENU SCREEN
9-23
Record
Voice TX > Record
Up to one minute of audio can be recorded onto a
microSD card for voice transmission. (p. 10-5)
Four independent voice audios can be memorized into
each memory T1 ~ T4.
While recording a QSO voice audio, this function is
disabled.
TIP: Be sure a microSD card is in the card slot.
Repeat Time (Default: 5sec)
Voice TX > TX Set > Repeat Time
Set the repeat period of time to between 1 and 15
seconds (in 1 second steps).
The transceiver repeatedly transmits the recorded
voice audio for this set period of time.
NOTE: The recorded voice audio is repeatedly
transmitted for up to 10 minutes. If 10 minutes
passes while transmitting, the transceiver
continues to transmit until the complete voice audio
transmission is nished.
TX Monitor (Default: ON)
Voice TX > TX Set > TX Monitor
Turn the TX Monitor function ON or OFF.
• OFF: The TX voice audio is not heard from the
speaker.
• ON: The TX voice audio is heard from the speaker.
<<TX>>
Voice TX > <<TX>>
The transceiver transmits the recorded voice audio.
If the memory T1 ~ T4 with “Repeat TX” is selected,
the recorded voice audio is repeatedly transmitted for
up to 10 minutes, at the “Repeat Time” interval.
(p. 10-6)
NOTE:
• If 10 minutes passes while transmitting, the
transceiver continues to transmit until the complete
voice audio transmission is nished.
• Any one of the following action will cancel the
transmission.
- Push [PTT].
- Turn OFF the transceiver, then turn it ON again.
- Push any key (except for [VOL] and [ ]).
Voice TX items
To Next Page
Loading...
