9
MENU SCREEN
9-4
Voice Memo Set the TX/RX voice recording options.
QSO Recorder Set QSO recorder options.
<<REC Start>>* Starts recording the received signal audio.
L While recording, <<REC Stop>> is displayed.
Play Files* Plays the recorded audio.
Recorder Set
REC Mode TX&RX or RX Only Selects whether or not to record the TX audio.
RX REC Condition Always or Squelch Auto Selects whether or not the squelch status
affects the RX voice audio recording.
File Split OFF or ON Selects whether or not to automatically create
a new le if transmission and reception, or
squelch status (open and close) is changed.
PTT Auto REC OFF or ON Turns the PTT Automatic Recording function
ON or OFF.
Player Set
Skip Time 3sec, 5sec, 10sec, or 30sec
Sets the Skip time to rewind or forward the
recorded audio when you push the fast-rewind
or fast-forward key during playback.
DV Auto Reply* Records a voice audio to use the Auto Reply
function in the DV mode.
Voice TX Set microphone voice recording options.
Record* T1~T4 Starts recording the microphone audio.
TX Set
Repeat Time 1sec~5sec~15sec Sets the repeat interval. The transceiver
repeatedly transmits the recorded voice audio
at this interval.
TX Monitor OFF or ON The TX Monitor function outputs the TX
voice audio from the speaker during voice
transmission.
<<TX>>* T1~T4, Repeat TX The transceiver transmits the recorded voice
audio.
GPS Set GPS options.
GPS Set
GPS Select OFF, Internal GPS,
External GPS, or Manual
Selects either the internal or an external
GPS receiver that the transceiver receives its
position data from.
Manual Position Manually enter your current position.
GPS Out (To DATA Jack) OFF or ON Turns the output of GPS information from the
internal GPS receiver to the [DATA] jack ON
or OFF.
*
Be sure to insert the microSD card into the transceiver before selecting these items.
Menu items and Default settings (Continued)
NOTE: The default settings shown in bold letters below are for the USA version.
The default settings may differ, depending on your transceiver version.