Icom ID-4100A

9
MENU SCREEN
9-3
NOTE: The default settings shown in bold letters below are for the USA version.
The default settings may differ, depending on your transceiver version.
DUP/TONE... Settings to access repeaters.
Offset Freq 0.000~0.600.00*
1
~59.995 MHz Sets the frequency offset for duplex (repeater)
operation.
Repeater Tone 67.0~88.5~254.1 Hz Selects a tone frequency used to access the
repeaters.
TSQL Freq 67.0~88.5~254.1 Hz Selects a tone frequency for the Tone Squelch
or the Pocket Beep function.
Tone Burst OFF or ON
Turns the Tone Burst function ON or OFF.
This function is used to suppress the RX
squelch tail noise in the FM mode, if you
transmit a signal which superimposes the
CTCSS tone or subaudible tone.
DTCS Code 023~754 Selects a DTCS (both encoder/decoder)
code for DTCS Squelch or the Pocket Beep
function.
DTCS Polarity Both N, TN-RR, TR-RN, or
Both R
Selects the DTCS polarity for the DTCS
Squelch or the Pocket Beep function.
Digital Code 00~99 Selects a digital code for the Digital Code
Squelch function.
Manage Memory Manages your Memory or Call channel data.
Memory CH ALL, A~Z Manages the Memory channels.
Call CH C0/C1(144):146.010 FM*
2
C0/C1(430):440.000 FM*
2
Manages the Call channels.
Scan Set scan options.
Pause Timer 2sec~10sec~20sec, or HOLD Selects the Scan Pause time. When receiving
signals, the scan pauses according to this set
period of time.
Resume Timer 0sec~2sec~5sec, or HOLD
Selects the Scan Resume time from a pause
after the received signal disappears.
Temporary Skip Timer 5min, 10min, or 15min Selects the Temporary Skip time. When the
time is set, specied frequencies are skipped
for this set period of time during a scan.
Program Skip OFF or ON Turns the Program Skip Scan function ON or
OFF for a VFO mode scan.
Bank Link
A:
✔
~Z:
✔
Selects banks to be scanned during a Bank
Link Scan.
Program Scan Edge 00~24 Sets the frequency ranges for a Program
scan.
Program Link
See page 9-19 for details of the preset values.
Sets the Link function for the Program Scan
Edge channels.
*
1
The default value may differ, depending on the frequency band and the transceiver version.
*
2
The default value may differ, depending on the transceiver version.
Menu items and Default settings
Previous view