9
MENU SCREEN
9-61
CI-V Transceive (Default: OFF)
Function > CI-V > CI-V Transceive
Turn the CI-V Transceive function ON or OFF.
• OFF: Turns OFF the function.
• ON: When you change a setting on one
transceiver, the same settings is automatically
changed on other connected transceivers or
receivers.
CI-V Bluetooth➝REMOTE Transceive Address
(Default: 00h)
Function > CI-V >
CI-V Bluetooth➝REMOTE Transceive Address
If you remotely operate your transceiver using
Bluetooth when “CI-V Transceive” is set to ON,
the devices in the same system are also externally
controlled through the external speaker (REMOTE)
jack.
To prohibit the external control of an Icom transceiver,
set this value to other than “00h.”
The control signal is output from the external speaker
(REMOTE) jack.
Select an address between 00h and DFh.
Power OFF (With No Controller)
(Default: ON)
Function > Power OFF (With No Controller)
Select whether or not to automatically turn OFF the
transceiver when the controller is disconnected from
the transceiver.
• OFF: The transceiver power is not turned OFF.
To turn OFF the transceiver, turn OFF the DC
supply, or disconnect the power cable.
When you connect the controller again, the
controller may perform incorrectly. This is not
the controller’s malfunction.
• ON: The transceiver is automatically turned OFF.
Function items (Continued)
To Next Page
Loading...
