Icom ID-4100A

2
SCAN OPERATION
2-5
D About a Scan name
When a Scan name is assigned, the name is
displayed in the Scan Type Select window. (p. 2-4)
L The Scan name is not displayed during a scan.
L See page 2-9 to enter the scan name.
When the Scan name is assigned
Scan name
When the Scan name is not assigned
Scan edges
D About a Program Link name
When a Program Link name is assigned, the name is
displayed in the Scan Type Select window. (p. 2-4)
L The Program Link name is not displayed during a scan.
L See page 2-9 to enter the program link name.
When the Program Link name is assigned
Program
Link name
When the Program Link name is not assigned
Program link
VFO mode scan (Continued)
D Setting the skip frequencies
You can set unnecessary frequencies as Skip
channels (PSKIP) to be skipped during a scan. The
Skip function speeds up a scan.
1. Start the VFO scan.
• When a signal is received, the scan pauses.
2. Push [QUICK].
3. Rotate [DIAL] to select “SKIP.”
• Sets the frequency as a Skip channel into empty
Memory channel 999.
• The entered Memory channel number blinks.
L If channel 999 already has content, the transceiver
automatically searches for another blank channel to
use. If there is no blank channel, a beep sounds, and
the frequency is not set as a Skip channel.
4. After setting, the scan resumes.
TIP: Once frequencies are set as a Skip channel,
these frequencies are skipped until clearing the skip
setting. To clear the skip setting, see page 2-8 for
details.
L The skip setting is also cleared when the Memory
channel set as a Skip channel is cleared. (p. 1-12)
Previous view