Icom ID-4100A

INTRODUCTION
iv
Controls used for text entry
[DIAL] (Rotate)
Selects
[]
Cancels
[ï]
Sets
[MODE]
Moves the
cursor to the left
[MW]
Moves the
cursor to the
right
[RX→CS]
Clears
[MENU]
Cancels
Entering and editing text
To change the character type
1. When not selecting text, or an entered text is
selected, push [QUICK].
2. Rotate [DIAL] to select the character type, then
push [ï].
Character
type
Selectable characters
and symbols
Character
conversion
AB
A to Z, (space)
A/a
ab
a to z, (space)
A/a
12
0 to 9, (space)
–
!”#
! " # $ % & ’ ( ) * + , - . / : ; < =
> ? @ [ \ ] ^ _ ` { | } ˜ (space)
–
TIP: When the character type is “AB” or “ab,” and
while entering a character, push [QUICK] to convert
between upper case and lower case letters.
Push
[QUICK]
• To insert a text, move the cursor to a place to
enter, then rotate [DIAL].
• To clear a character, push [RX→CS].
• To consecutively clear characters, continuously
hold down [RX→CS].
• When the character type is “AB” or “ab,” and while
entering a character, push [QUICK] to convert
between upper case and lower case letters.
[QUICK]
Selects the
character type
Previous view