Icom ID-4100A

INTRODUCTION
vi
Entering and editing text (Continued)
D How to enter
(Example: Entering “Calling” as a Memory name.)
1. Push [MW].
2. Rotate [DIAL] to select “Manage Memory,” then
push [ï].
• Displays the MANAGE MEMORY screen.
3. Select “Memory CH,” then push [ï].
4. Select “ALL,” then push [ï].
• Displays the ALL screen.
5. Rotate [DIAL] to select the Memory channel to
enter a name, then push [QUICK].
6. Select “Edit,” then push [ï].
7. Select “NAME,” then push [ï].
• Enters the name entry mode.
8. Push [QUICK].
9. Select the character type, then push [ï].
10. Rotate [DIAL] to select a character, then push [ï].
(Example: C)
InformationL
• To move the cursor forward, push [MW].
• To move the cursor backward, push [MODE].
• To insert a text, move the cursor to a place to enter,
then rotate [DIAL].
• To clear a character, push [RX→CS].
• To consecutively clear characters, continuously hold
down [RX→CS].
• When the character type is “AB” or “ab,” and while
entering a character, push [QUICK] to convert
between upper case and lower case letters.
11. Repeat step 8 ~ 10 to enter a name.
(Example: Calling)
12. After entering, push [ï].
13. Select “<<Overwrite>>,” then push [ï].
• The conrmation dialog “Overwrite?” is displayed.
14. Select <YES>, then push [ï].
• Beeps sound, and writes the entered name to the
channel.
Previous view