4
D-STAR OPERATION
4-46
If you make a local area call with a gateway setting
still selected in “TO,” the destination repeater will be
busy while you transmit.
So the stations that use that repeater as their Access
repeater cannot access it, as shown below.
BE SURE to set CQCQCQ in “TO” when you intend to
make a local call, or after you nish a Gateway call.
Example: JM1ZLK wants to make a Local area call.
NOTE: With this setting, the Local area call can be
made, but the destination repeater, selected in “TO,”
is also busy while you transmit.
So the station that uses the destination repeater as
their Access repeater cannot access it.
JM1ZLK listening
on JP1YIU port A
for a local call...
JM1ZLK listening
on JP1YIU port A
for a local call...
JM1ZLK listening
on JP1YIU port A
for a local call...
His setting is incorrect!
I cannot access the
repeater!
Caller
(JM1ZLK)
Hamacho area
Hirano area
Called
Hamacho repeater
Hirano repeater
JM1ZLK’s setting
The destination (“TO”) setting is incorrect.
Correct setting
To make a Local area call, set the
destination (“TO”) to “CQCQCQ.”
See page 4-9 for details.
Your setting is correct?
To Next Page
Loading...
