76 Intel® Server Board S1200BT Service Guide
7. Twist the heatsink slightly to break the seal between the heatsink and the processor.
8. Lift the heatsink from the processor. If it does not pull up easily, twist the heatsink
again. Do not force the heatsink from the processor. Doing so could damage
the processor.
9. Lift the processor lever.
10. Raise the CPU load plate.
11. Remove the processor.
12. If installing a replacement processor, see “Installing the Processor”. Otherwise,
install the protective socket cover over the empty processor socket and reinstall the
chassis cover.
Installing a PCI Card
This system does not include peripherals and add-in cards; you must purchase them
separately. The riser card at PCI slot 6 of the board supports a low-profile, half-length PCI
Express* add-in card. Refer to the R1304BTLSFAN/S1304BTLSHBN System for more
detailed information on how to install a PCI card.
Note: You must attach add-in cards to a riser card when the riser card is removed from
the chassis.
1. Remove the screw that attaches the PCI bracket shield to the rear of the chassis to
remove the shield. Retain the screw.
Figure 52. Removing the PCI Riser Assembly from the Server System
2. Insert the PCI card edge connector in the slot on the PCI riser.
AF003683
Riser Card
Connector
To Next Page
Loading...
Need help?
General
