Intel S1200BT - BIOS Setup Utility Screens

Intel® Server Board S1200BT Service Guide 21
Setup Screen Menu Selection Bar
The Setup Screen Menu selection bar is located at the top of the BIOS Setup Utility
screen. It displays tabs showing the major screen selections available to the user. By using
the left and right arrow keys, the user can select the listed screens. Some screen selections
are out of the visible menu space, and become available by scrolling to the left or right of
the current selections displayed.
BIOS Setup Utility Screens
The following sections describe the screens available in the BIOS Setup utility for the
configuration of the server platform.
For each of these screens, there is an image of the screen with a list of Field Descriptions
which describe the contents of each item on the screen. Each item on the screen is
hyperlinked to the relevant Field Description. Each Field Description is hyperlinked back
to the screen image.
These lists follow the following guidelines:
• The text heading for each Field Description is the actual text as displayed on the
BIOS Setup screen. This screen text is a hyperlink to it’s corresponding Field
Description.
• The text shown in the Option Values and Help Text entries in each Field Description
are the actual text and values are displayed on the BIOS Setup screens.
• In the Option Values entries, the text for default values is shown with an underline.
These values do not appear underline on the BIOS Setup screen. The underlined text
in this document is to serve as a reference to which value is the default value.
• The Help Text entry is the actual text which appears on the screen to accompany the
item when the item is the one in focus (active on the screen).
• The Comments entry provides additional information where it may be helpful. This
information does not appear on the BIOS Setup screens.
• Information enclosed in angular brackets (< >) in the screen shots identifies text that
can vary, depending on the option(s) installed. For example, <Amount of memory
installed> is replaced by the actual value for “Total Memory”.
<F10> Save and Exit Pressing the <F10> key causes the following message to
display:
Save configuration and reset?
Yes No
If "Yes" is highlighted and <Enter> is pressed, all changes
are saved and the Setup is exited. If "No" is highlighted
and <Enter> is pressed, or the <Esc> key is pressed, the
user is returned to where they were before <F10> was
pressed without affecting any existing values.
Key Option Description