Intel S1200BT - Power Supply; Optional Hardware

Intel® Server Board S1200BT Service Guide 15
Power Supply
A minimum of 350 W is required. Your supply must provide a minimum of 3 A of 5-V
standby current or the board will not boot.
Optional Hardware
Intel
®
SAS RAID Module
The Intel
®
Server Board S1200BTL provides a SAS Mezzanine slot (J2H1) for the
installation of an optional Intel
®
SAS RAID Module. Once the optional Intel
®
SAS Entry
RAID Module is detected, the x4 PCI Express* links from the chipset to the SAS
Mezzanine slot. Three modules are supported in this platform: AXXRMS2AF040,
AXXRMS2LL040, and AXX4SASMOD.
The optional Intel
®
Integrated RAID Module AXXRMS2AF040 is an intelligent custom
board-to-board PCI Express* 2.0 compliant interface RAID adapter with an integrated
LSI* LSISAS2008 Processor Chip, providing both a SAS controller and RAID engine.
With four independent ports supporting 6 Gbps and 3 Gbps SAS data transfers using four
individual SAS/SATA connectors.
The optional Intel
®
RAID Module AXXRMS2LL040 is an intelligent custom board-to-
board PCI Express* 2.0 compliant interface RAID adapters with an integrated LSI*
LSISAS2008 Processor Chip, providing both a SAS controller and RAID engine. With
four independent ports supporting 6-Gbps and 3 Gbps SAS data transfers using four
individual SAS/SATA connectors, The Intel
®
RAID Module AXXRMS2LL040 provides
reliable and fault-tolerant disk subsystem management based on the Intel
®
Entry
Hardware RAID (IR) Stack.
The optional Intel
®
SAS Entry RAID Module AXX4SASMOD provides four SAS
connectors that support up to four hard drives with a non-expander backplane or up to
eight hard drives with an expander backplane.4 ports full featured SAS/SATA hardware
RAID through optional Intel
®
Integrated RAID Module SROMBSASMR
(AXXROMBSASMR), provides RAID 0, 1, 5, 6 and striping capability for spans
10, 50, 60.