Before You Begin
x ED40 Decode Board Integration Guide
Before You Begin
This section provides you with safety information, technical support
information, and sources for additional product information.
Safety Information
Your safety is extremely important. Read and follow all warnings and cautions in
this document before handling and operating Intermec equipment. You can be
seriously injured, and equipment and data can be damaged if you do not follow
the safety warnings and cautions.
This section explains how to identify and understand dangers, warnings,
cautions, and notes that are in this document. You may also see icons that tell you
when to follow ESD procedures and when to take special precautions for
handling optical parts.
Global Services and Support
Warranty Information
To understand the warranty for your Intermec product, refer to your OEM Sales
Agreement.
Disclaimer of warranties: The sample code included in this document is
presented for reference only. The code does not necessarily represent complete,
tested programs. The code is provided “as is with all faults.” All warranties are
expressly disclaimed, including the implied warranties of merchantability and
fitness for a particular purpose.
A warning alerts you of an operating procedure, practice, condition, or
statement that must be strictly observed to avoid death or serious injury to
the persons working on the equipment.
A caution alerts you to an operating procedure, practice, condition, or
statement that must be strictly observed to prevent equipment damage or
destruction, or corruption or loss of data.
This icon appears at the beginning of any procedure in this manual that
could cause you to touch components (such as printed circuit boards) that
are susceptible to damage from electrostatic discharge (ESD). When you see
this icon, you must follow standard ESD guidelines to avoid damaging the
equipment you are servicing.
Because finger oils can impede the performance of scanner parts and
dissolve the reflective coating of the plastic mirrors, always wear finger cots
or non-powdered latex gloves when handling optical parts.
Note: Notes either provide extra information about a topic or contain special
instructions for handling a particular condition or set of circumstances.
To Next Page
Loading...