Chapter 4 — ED40 Setup
22 ED40 Decode Board Integration Guide
Setting Up Software on the ED40
You can set up your ED40 using one of these two methods:
• Using the EasySet® configuration application
• Using the Intermec Scanner Control Protocol (ISCP)
Using the EasySet Software
EasySet is an Intermec configuration application that is available from the
Intermec web site at www.intermec.com/EasySet. Use EasySet to create
configuration bar codes that you can scan. For more information about EasySet,
see the EasySet software.
Using the Intermec Scanner Control Protocol (ISCP)
The Intermec Scanner Control Protocol (ISCP) is a secure structured protocol
used to communicate between an Intermec scanner and a host system. You can
use ISCP to send configuration commands directly from your host system.
To help you get started with ISCP, Intermec provides the following ISCP support
documents and tools:
• Intermec Scan Engine Software Development Kit (SDK) including:
• ISCP—Structure & Frame Descriptions Technical Reference Manual (P/N 3-
122049-15)
• ISCP Command Set Help file (P/N 3-122049-16)
• DLL file for ISCP implementation
• API documentation that describes how to use the DLL file
• Sample application (for several operating systems)
• Sample application source code
• List of supported ISCP commands and their default values for your imager
These are available upon request from your Intermec OEM Sales Representative.
To Next Page
Loading...