ED40 Decode Board Integration Guide iii
Document Change Record
This page records changes to this document. The document was originally
released as a DRAFT.
Revision Date Description of Change
A5/2010
• Updated all mechanical dimensions for Appendixes A,
B and C.
• Added USB information in Setup chapter.
• Added current measurements for each imager.
• Added EMI information.
• Added thermal considerations.
• Added hibernate mode information.
B 04/2011
• Corrected regulatory information.
• Added EA30 imager appendix including information
on setting up motion tolerance.
• Corrected EA21 mounted imager position graphic
(position 1 and 2 were switched).
• Added inrush current graphics for EA11, EA20X, EA21
and EA30.
• Changed instructions for downloading the USB driver.
• Added information on Video and ISCP configuration
over USB.
• Added advanced setup section with configuration bar
codes.
• Added data strings to all configuration bar codes
• Updated all two piece design photos with latest photos
(including sheild).
To Next Page
Loading...