INVT Goodrive300-01A-RT Series - Page 67

Goodrive300-01A-RT series integrated machine Function description
-61-
Function
code
Name
Description
Default
Modify
can be reduced to improve the power factor
of the motor.
P13.02
Pull-in current 1
0.0%–100.0% (of the rated current of the
motor)
Pull-in current 1 is the pole positioning
current which is used to increase the torque.
20.0%
○
P13.03
Pull-in current 2
0.0%–100.0% (of the rated current of the
motor)
10.0%
○
P13.04
Switching frequency of
pull-in current
0.00Hz–P00.03 (max. output frequency)
30.00Hz
○
P13.05
High-frequency
superposing frequency
(reserved)
200Hz–1000Hz
500Hz
◎
P13.06
High--frequency
superposing voltage
0.0–300.0% (of the rated voltage of the
motor)
40.0%
◎
P13.08
Control parameter 1
0–FFFF
0x120
○
P13.09
Control parameter 2
0–300.00
5.00
○
P13.11
Maladjustment
detection time
The function code is used to adjust the
responsiveness of anti-maladjustment
function. If the load inertia is large, increase
the value of P13.11 properly, however, the
responsiveness may slow down accordingly.
Setting range: 0.0–10.0s
0.5s
○
P13.12
High-frequency
compensation
coefficient
The function code is valid when the motor
speed exceeds the rated speed. If motor
oscillation occurred, adjust this parameter
properly.
Setting range: 0.0–100.0%
50.0%
○
P13.14
Hold time of
short-circuit braking for
start
0.00–50.00s
0.00
○
P13.15
Hold time of
short-circuit braking for
stop
0.00–50.00s
0.00
○