Chapter 4 IP Testing
Running Traceroute
HST-3000 Ethernet Testing User’s Guide
159
3 Establish an IPoE connection or a PPPoE session:
– If you are transmitting IPv4 traffic, see
“Establishing an
IPoE connection for IPv4 traffic” on page 122, or
“Establishing a PPPoE session” on page 128.
– If you are transmitting IPv6 traffic, see “Establishing an
IPoE connection for IPv6 traffic” on page 124.
4 Press the Configure key, and then use the left and right
arrows to go to the Traceroute menu (see Figure 32).
5 Specify values for the following settings:
Figure 32 Traceroute configuration menu (IPv4 settings)
IPv4 IPv6 Setting Parameters
Yes Yes Destination Type Specify how you will identify
the far end device you are trac-
ing the route to:
– IP Address - to type the
address of the device.
– Host Name - to type name
of the device.
Yes Yes Destination IP
(if Destination Type is IP
Address)
Enter the destination IP
address of the device.
To Next Page
Loading...
