Chapter 8 SAMComplete Testing
Specifying settings
HST-3000 Ethernet Testing User’s Guide
233
Then specify the following:
Setting Parameters
Loop Type
(L2 applications only)
– Unicast - sends traffic to a
single destination address
and network device.
– Broadcast - sends traffic to
all network devices on the
link.
– NOTE: If you select Unicast,
you can optionally use the
Discover soft key to discover
other instruments on the net-
work, and then select the
destination address for the
device you want to transmit
traffic to. For details, see
“Using J-Connect to dis-
cover another JDSU test
set” on page 21
Length Type
(L3 applications only)
– Frame Length - Changing
Service Properties > Service
Type to “Voice, HDTV or
SDTV” for any service forces
Length Type to Frame
Length.
– Packet Length - Changes
the Service Properties Ser-
vice Type to “Data” for all
services.
Source MAC
(multi-stream applica-
tion only)
– Factory default
– User defined (and enter
the MAC address)
To Next Page
Loading...
