JDS Uniphase HST-3000 - Page 256

Chapter 8 SAMComplete Testing
Specifying settings
234 HST-3000 Ethernet Testing User’s Guide
ARP Mode
(L3 applications only)
– Enable - Enable ARP mode
if you want the HST to issue
an ARP request to automati-
cally determine the MAC
address of its link partner. In
most instances ARP should
be enabled.
– Disable - If you disable ARP
Mode, be certain to specify
the Destination MAC
address for the HST’s link
partner (on the Ethernet
menu).
Source Type
(L3 applications only)
– DHCP - allows the unit to
obtain an IP address for
each stream from a DHCP
server.
– Static - allows you to manu-
ally specify the IP, subnet,
and gateway addresses.
– Static IP-Per Stream allows
you to manually specify the
IP and other addresses for
each stream.
Source IP
(L3 applications only)
If the Source Type is Static,
enter the source IP address car-
ried by all traffic generated by
your unit.
Subnet Mask
(L3 applications only)
If the source IP type is Static,
enter the subnet mask.
Default Gateway
(L3 applications only)
If the source IP type is Static,
enter the default gateway
address.
Setting Parameters