Chapter 8 SAMComplete Testing
Specifying settings
HST-3000 Ethernet Testing User’s Guide
235
6 Select Service Properties, and then specify the following
settings:
7 Select one of the following:
– If running a single-stream application, select Ethernet.
– If running a multi-stream application, select Network
Settings Ethernet.
Setting Parameter
Service Name Enter the name of the service, up
to 21 characters.
Service Type Select the service type: Data,
Voice, HDTV, SDTV.
NOTE: This setting affects the
Length Type on the Service Set-
tings. Voice, HDTV or SDTV
forces the Length Type to Frame
Type; and, reversely, changing
the Length Type to Packet Length
forces Service Type to Data.
Frame Type Select the frame type: DIX, 802.3
Encapsulation Select the encapsulation: None,
VLAN, Q in Q
Codec
(Voice Service Type)
Specify the Codec to use for voice
calls.
Sampling Rate
(Voice Service Type)
Select a sampling rate between
10 and 60 ms.
# Calls
(Voice Service Type)
Specify the number of calls to
place (max number depends on
CIR for codec and interface rate)
# Channels
(HDTV or SDTV Ser-
vice Type)
Specify the number of calls to
place (max number depends on
CIR for codec and interface rate)
Compression
(HDTV or SDTV Ser-
vice Type)
Specify MPEG2 or MPEG4 com-
pression.
To Next Page
Loading...
