Chapter 3 Ethernet Testing
Initializing the link for Ethernet testing
48
HST-3000 Ethernet Testing User’s Guide
– If you turned auto-negotiation OFF, the HST immediately
transmits idles over the circuit.
To initialize an Ethernet link
1 If you haven’t already done so, launch your application
(see “Launching an application” on page 28), and then
select your test (see the appropriate procedure below):
– “Selecting a layer 2 test” on page 46
– “Selecting a layer 3 IP test” on page 120
– “Selecting a layer 4 TCP/UDP test” on page 165
– “Selecting a multiple streams test” on page 182
2 Press the Configure navigation key.
A configuration menu appears.
3 Use the left and right arrow keys to go to the Link Init
configuration menu. Figure 19 illustrates the settings for
1G optical applications.
Figure 19 Link Init configuration menu
To Next Page
Loading...
