Chapter 3 Ethernet Testing
Initializing the link for Ethernet testing
HST-3000 Ethernet Testing User’s Guide
49
– If you selected 10/100/1G application, proceed to
step 4.
– If you selected an optical 1G or 100M application,
proceed to step 5.
4 If you selected 10/100/1G application, specify the
following settings:
Setting Parameters Applicable
Auto Neg – On
– Off
Always
NOTE:
If you turn auto-negoti-
ation on, flow control is
also turned on auto-
matically, and the Flow
Control setting does
not appear on the
menu.
Flow Control – On
– Off
If Auto Neg value is Off
Speed
(Mbps)
– 10
– 100
– 1000
– 10, 100 Always
– 1000, If Auto Neg
value is On
Duplex – Half
– Full
Always
Pause
Quanta
– Enter a
pause
quanta
ranging
from 0 to
65535.
Always
To Next Page
Loading...
