4-43
4.8 User Menu Setting
・Function・ Two kinds of (user 1 and user 2) arbitrary menu settings can be registered.
It is possible to use it by registering what set according to the fishing method, the fishery,
and the season such as ranges on the current measurement depth of layer and the [FISH]
screen, and reading it if necessary.
Operation Standard Menu: [MENU] key/Menu screen/Initial setting≫/[ENT] key/"Installation setting"
menu/Master reset User menu setting≫/[ENT] key/"Master reset User menu setting" menu
1. Read out the setting Value
・Function・ The registered menu set value is read. (*1)
Read out the setting value: [ Cancel/Factory/User 1/User 2/External]
User 1 or user 2 is selected from among the menu, and it executes it with the [ENT] ke y.
After it executes it, it ends with the [MENU] key.
Execute "2. Write in the setting Value" when the menu setting is changed after it reads
and it registers again.
Factory: A set value when the factory is shipped is read. (*2)
User 1: The set value being registered by user 1 is read. An initial value is the same as the
shipment value.
User 2: The set value being registered by user 2 is read. An initial value is the same as the
shipment value.
External: It is the menu for the service man. An error is displayed.
Operation Standard Menu: "Installation setting" menu/"Master reset User menu setting"/Read out
the setting value: Cancel
2. Write in the setting Value
・Function・ A present menu setting value is registered to user 1 or user 2. (*1)
Write in the setting value: [ Cancel/Operate≫ ].
When Operate≫ is selected and the [ENT] key is pushed, following "Write in the setting
value" menu is displayed.
Write in the setting value
Write in the Value
of menu Displayed
Cancel User 1 User 2
User 1 or user 2 is selected from among the menu, and it executes with the [ENT] k e y. (*3)
After it executes, it ends with the [MENU] key.
Execute "1. Read out the setting Value" when you call the written menu.
Operation Standard Menu: "Installation setting" menu/"Master reset User menu setting"/2.Write in
the setting value: Cancel/Operate≫/ "Write in the setting value" menu / Write in the value of
menu display: Cancel
*1 Other operations (The panel operation is included) cannot be done while being reading the registration value or writing it. The
menu value set to read the registered menu value now is overwrote and deleted.
Register the menu to user 1 or user 2 beforehand when the saving is necessary. It is possible to return to the last menu setting
value with [UNDO] key before "Submenu" is ended it.
*2 A set value when the factory is shipped becomes an initial value of the menu setting. Refer to 12.1 “Menu Table”
*3 It returns to the previous setting value with [UNDO] key before "Execution menu" is ended it.