3-9
3.2.3 Basic Operation of Menu
1) Standard menu
How to open menu
The menu display opens pushing the [MENU] k ey.
*The menu screen is displayed at the center of screen.
*The menu Screen is displayed by the half penetration,
and can select the permeability. (*1)
How to close menu
When the menu is closed, it closes pushing the [MENU] key again. Or, even if the lower menu
[display/end] is selected with cursor key (*2), and the [ENT] key is pushed, it closes.
How to move to the lower hierarchy (submenu) of the menu
The submenu mark ”《” has adhered to the menu with the lower hierarchy.
After the submenu ”
《” is selected with the cursor key to move to the submenu, push the [ENT] key.
How to move to the higher hierarchy (submenu) of the menu
After selecting the lower “Display/Return] in menu with the cursor key, push the [ENT] key in the return
from the submenu to the higher hierarchy.
How to decide the item
A set value is selected with the cursor key when the item is decided or the numerical value is input.
And, the thing that the set item reverses the character is confirmed. After that, it decides it pushing the
[ENT] ke y.
Selecting by [・/・] key
When this display is in the menu, the setting is selected with the right and left cursor key.
Inputting by numeric volume key
When this display is in the menu, a set value is input with numeric key (1,2･･･9,0) of the keyboard.
Standard menu list
Refer to the list “3.2.1 Standard Menu Composition” or “12.1.1 Standard Menu”
*1 Display of permeability setting menu: Menu/Initial setting/Installation setting/Menu permeability
*2 After moving to up/down by [▲/▼] key, select the setting value with [ ] key.
▲
▼
To Next Page
Loading...