3-10
2) Selection frame menu
"Selection frame" (outside frame with square yellow bold line) is
displayed on the screen being displayed now. It moves to the table
and the graph where it wants to set this "Selection frame".
Under such a condition, when the [MENU] key is pushed, a set
menu corresponding to the part selected by "Selection frame" is
displayed.
How to display the selection frame
When the [□] key is pushed, the selection frame is displayed on the screen.
Refer to “Fig. 3.2.1”
How to close the selection frame
When the [□] key is pushed again with the selection frame displayed, the selection frame disappears
from the screen.
How to move the selection frame
Move by [ (Right/left)] cursor key.
For instance, the selection frame moves
from "Circle Graph" to "Fore/After and
Port/Starboard ship speed" in the lower
when the [ ] key is pushed once from Fig.
3.2.1.
The movement order is a little different
according to the screen.
How to display selection frame menu
It moves to the table and the graph where it wants to set "Selection
frame" with the right and left cursor key. Under such a condition,
when the [MENU] key is pushed, a set menu corresponding to the
part selected by "Selection frame" is displayed.
Whenever the [PLOT] key is pushed, the selection frame menu
can sequentially be moved as shown in a left figure.
How to close selection frame menu
When the menu is closed, it closes pushing the [MENU] key again. Or, even if the lower menu
[display/end] is selected with cursor key, and the [ENT] key is pushed, it closes.
How to move to the lower hierarchy of the menu
This procedure is the same as the above-mentioned "Standard menu".
How to move to the higher hierarchy of the menu
This procedure is the same as the above-mentioned "Standard menu".
How to decide the item
This procedure is the same as the above-mentioned "Standard menu".
Selection frame menu list
Refer to the list “3.2.2 Selection Frame Menu Composition” or “12.1.2 Selection Frame Menu”
▲
▼
Menu
Screen
"Selection frame" is moved to
the table and the graph
where it wants to set the
menu.
Ex.: [CURR]1 Screen
Circle Graph Display
The selection frame moves
to "Counterclockwise" with
the [
] or [ ▼ ] key.
The selection frame moves
to "Clockwise" with the
[ ] or [ ▲ ] key.
▼
▲
▲
To Next Page
Loading...