11-3
11.1 Specifications
11.1.1 General Specification
:2 axis dual beam pulse Doppler
Frequency JLN-650
JLN-652
:15”color LCD, 1024X768 pixels (XGA)
Power supply JLN-650
JLN-652
100 - 230VAC -10% +10%:
24VDC -10% +30%
:
℃~+
℃/
:
+
℃
:
~
、
:
2
~
Current measurement performance
~
accuracy
:Large one either ±2%rms or 0.2kn
Note: When there is a bubble right under transducer or the roll-pitch of the hull
is large, the unexpected value exclusion processing to keep the measurement
accuracy is done. However, when they are excessive too large, there is a
possibility that the direction and speed of the current is mis-displayed.
Current direction
display
: All surroundings (360°), numerical values, and 32 point bearing display
: Max. 50 Layer (A numeric display shows five arbitrary layers.)
depth of layer
: 2m (Shallow-water mode)
: 12m (Std. mode)
depth of layer
JLN-650
JLN-652
:160m
: 100m
Note: The maximum value of measurement depth of layer is 80% or less of
depth.
%-value decreases as depth becomes shallow. Moreover, the maximum value
of the measurement depth might be different depending on reflection strength in
sea depth
~
500m It is possible to set it arbitrarily.
Ship speed measurement performance
Fore/After
measurement range
~
Port/Starboard
measurement range
~+
Large one either ±1%rms or 0.1kn
bottom
: Ground speed measurement depth: 5
~
: Water speed measurement depth: More than 10m
(Ground speed/Water speed simultaneous display)
Note: The measurement depth might be different according to the state of the
bottom.
~
Large one either ±1%rms or 0.1nm
Manual bottom tracking function