Travel conduct
The operator must adapt the travel speed to local conditions. The operator must
travel slowly for example when negotiating bends or narrow passageways, when
passing through swing doors, at blind spots and when entering and leaving the
narrow aisle. The operator must always observe an adequate braking distance
between the forklift truck and the vehicle in front and must be in control of the truck
at all times. Abrupt stopping (except in emergencies), rapid U turns and overtaking at
dangerous or blind spots are not permitted. Do not lean out or reach beyond the
working and operating area.
Do not use a mobile phone or walkie-talkie without a handsfree device while
operating the truck.
WARNING!
What to do if the industrial truck tips over
If the truck is in danger of tipping over, the operator should not jump out of the truck,
and must keep his whole body inside the operator position.
The operator:
u
Must not leave the driver's seat under any circumstance
u
Must not jump off the truck
u
Must hold onto the operator position with both hands
u
Must brace himself with both feet
u
Must lean against the direction of fall
u
Must not undo the seat belt
WARNING!
Electromagnetic influence can result in accidents
Strong magnets can cause electronic components such as Hall sensors to become
damaged, resulting in accidents.
u
Do not use magnets in the operating area of the truck. Exceptions to this rule are
commercial, weak clamping magnets for attaching notices.
134
04.19 en-GB
To Next Page
Loading...
Need help?
General
