Switching on the truck
Requirements
– Visual inspections and operations to be
performed before starting daily
operation, see page 117.
– Connect the battery to the truck.
– Insert and lock the battery latch.
– Insert and lock the side panels correctly.
– Close the battery cover, see page 76.
– Enter the operator position, see
page 121.
Procedure
• Turn the EMERGENCY DISCONNECT switch (9) to unlock it.
Z
Press the Emergency Disconnect (9) immediately if the truck starts to move or lift
as soon as it is switched on. Brief steering movements caused by steering
referencing are permissible.
• Switch on the truck, to do this:
• Insert the key in the key switch (8) and turn it as far right as it will go.
• Hold the card or transponder in front of the ISM access module (23) and
depending on the setting press the green button on the ISM access
module (23) (o).
140
04.19 en-GB
To Next Page
Loading...
Need help?
General
