Procedure
• Press the dead man's switch.
• Drive the truck carefully up to the storage location.
• Raise/lower the load handler so that the load can enter
the storage location without colliding.
• Do not press the dead man's switch.
• Carefully set the load into its storage location.
• Press the dead man's switch.
• Carefully lower the load handler so that the forks are
clear of the load.
Z
Avoid setting down the load abruptly to avoid damaging
the load, load handler and the rack.
• Do not press the dead man's switch.
• Slowly retract the load handler to the home position,
see page 192.
• Press the dead man's switch.
• Fully lower the load handler.
The load has been deposited correctly.
204
04.19 en-GB
To Next Page
Loading...
Need help?
General
