Park the truck securely,
Procedure
• Park the truck on a level surface.
• Fully lower the load handler (28):
• Press the dead man's switch (20).
• Turn the "hydraulic functions" control lever (113) anticlockwise.
• Traverse and rotate the attachment into the home position, see page 192.
• Switch off the truck, to do this:
• Turn the key in the key switch (8) to the left as far as the stop and remove the
key.
•
Press the red button of the ISM access module (o) twice in a row.
NOTICE
Peculiarity when switching off the truck with the ISM access module
After the automatic emergency stop system has been activated, the truck cannot be
switched off after the red button of the ISM access module has been pressed twice.
The truck controller prevents the truck from being switched off, see page 211.
u
To consciously switch off the truck, press the red button again and hold it down for
at least 2 seconds.
• Press the emergency disconnect switch (9).
The truck is now securely switched off.
4.16.1
Traversing and rotating the attachment in the home position (t)
Requirements
– Prepare the truck for operation, see page 138 or see page 139.
Procedure
• Do not press the dead man's switch (20).
• Traverse the attachment to the right or left end position of the swivel traverse
frame (25), see page 177.
• Rotate the forks (28) parallel to the swivel traverse frame (25), see page 178.
The driver's display shows the "attachment in home position" symbol.
192
04.19 en-GB
To Next Page
Loading...
Need help?
General
