• Remove the set screws (184) from the bracket (185) above the drive wheel
brake (187).
• Insert the set screws (184) into the drive wheel brake (187) above the drive
motor (186) and tighten them with the two hex. nuts.
Z
The two set screws (184) are used to tension (unlock) the compression springs
which activate the parking brake, so that the truck does not brake when de-
energised.
• Fit the drive compartment cover (35), see page 334.
• Remove the wedges.
The drive wheel brake is now released and the truck can be moved. The truck can
now be towed or pushed.
226
04.19 en-GB
To Next Page
Loading...
Need help?
General
