8.6.1 Entering area recognition (zones)
Z
Area recognition can occur manually or automatically depending on the setting.
Automatic area (zone) detection
Z
The area is automatically recognised by the truck. There is no requirement for the
operator to make an entry.
Manual area recognition (zone) entry
Requirements
– Prepare the truck for operation, see
page 138 or see page 139.
– Drive the truck into the narrow aisle and
establish automatic guidance, see
page 159.
Procedure
• Press the "Select" button (151) in the
cursor field.
• Using the numerical keypad (112) enter
the area.
• If an incorrect entry is made it can be
deleted by pressing the “CE” button on
the numerical keypad (112).
• Press "OK" on the numerical
keypad (112) to save the area entry.
The entered zone is now shown in the
driver's display above the “zone selection”
symbol (206).
266
04.19 en-GB
To Next Page
Loading...
Need help?
General
