Automatic stacking operation with the
"hydraulic functions" control lever
(version B)
– Press the dead man's switch (20).
– Stacking/retrieval can be performed when
the selected nominal height has been
reached.
– Do not press the dead man's switch (20).
– The given direction for the stacking
operation must be confirmed and adhered
to throughout the stacking operation via
the "hydraulic functions" control
lever (113):
• "Left" stacking operation = turn the
"hydraulic functions" control lever (113)
anticlockwise and hold it down until the
operation is complete.
• "Right" stacking operation = turn the
"hydraulic functions" control lever (113)
clockwise and hold it down until the
operation is complete.
Z
The hydraulic speeds are fixed and cannot be influenced.
The hydraulic functions stop when the "hydraulic functions" control lever (113) is
released. The stacking operation continues when the "hydraulic functions" control
lever (113) is actuated again.
Pressing one of the "attachment traverse" (120) or "fork carriage rotate" (119) keys
cancels the automatic stacking operation. The driver is notified of this via an audible
signal. After the cancellation the operator must complete the stacking operation
manually, see "Manual stacking operation".
During the positioning procedure another compartment can be entered. This entry is
shown for approx. 1 sec. in the driver's display and stored in the cache. After
stacking, the shelf is automatically taken from the intermediate log.
Z
The stacking operation can be cancelled by pressing the “CE” button on the
numerical keypad (112) or by pressing the emergency disconnect switch. No "order
processed" message is sent to the truck terminal.
278
04.19 en-GB
To Next Page
Loading...
Need help?
General
