Juniper SRX100 Hardware Guide

Chapter 9 Connecting, Grounding, and Powering On the SRX100 Services
Gateway 45
Connecting the SRX100 Services Gateway to the Power Supply ....................45
Connecting and Organizing Interface Cables to the SRX100 Services
Gateway ..................................................................................................46
Grounding the SRX100 Services Gateway ......................................................47
Powering On and Powering Off the SRX100 Services Gateway .....................48
Powering On the SRX100 Services Gateway ...........................................48
Powering Off the SRX100 Services Gateway ...........................................49
Chapter 10 SRX100 Services Gateway Memory Upgrade 51
Upgrading the SRX100 Services Gateway Low Memory Version to a High
Memory Version .....................................................................................51
Chapter 11 SRX100 Services Gateway Autoinstallation 53
SRX100 Services Gateway Autoinstallation Overview ....................................53
Chapter 12 Establishing Basic Connectivity for the SRX100 Services
Gateway 55
SRX100 Services Gateway Basic Connectivity ...............................................55
SRX100 Services Gateway Basic Connectivity Overview .........................55
SRX100 Services Gateway Basic Connectivity Settings ............................56
Built-In Ethernet Ports for the SRX100 Services Gateway ........................58
Management Access for the SRX100 Services Gateway ..........................59
Connecting to an SRX100 Services Gateway .................................................60
Connecting an SRX100 Services Gateway to the J-Web Interface ............60
Connecting an SRX100 Services Gateway to the CLI Locally ...................62
Connecting an SRX100 Services Gateway to the CLI Remotely ...............64
Connecting the Modem at the SRX100 Services Gateway End ................64
Connecting the Modem to the Console Port on the SRX100 Services
Gateway ...........................................................................................65
Connecting to the CLI at the User End for the SRX100 Services
Gateway ...........................................................................................66
Configuring Basic Connectivity Settings on the SRX100 Services
Gateway ..................................................................................................67
Configuring Basic Settings for the SRX100 Services Gateway with J-Web
Quick Configuration .........................................................................67
Configuring Basic Settings for the SRX100 Services Gateway with a
Configuration Editor .........................................................................70
Displaying Basic Connectivity Configurations for the SRX100 Services
Gateway ...........................................................................................73
SRX100 Services Gateway Secure Web Access Overview ........................74
Table of Contents ■ ix
Table of Contents

Juniper SRX100 Specifications

General

Routing protocols	BGP, IS-IS, MPLS, OSPF
Switching protocols	VLAN 802.1Q, 802.3ad/LACP, STP
Supported network protocols	IPv4, IPv6, CLNS
Firewall security	Yes
Security algorithms	3DES, DES
Authentication method	RADIUS, RSA SecureID, LDAP
VPN support	IPsec VPN
Data transfer rate	0.1 Gbit/s
Input voltage	100 - 240 V
Input frequency	50/60 Hz
Heat dissipation	35 BTU/h
Power requirements	100-240, 50/60
Power over Ethernet (PoE)	No
Power consumption (typical)	30 W
Safety	UL 60950-1, CSA 60950-1, AS / NZS 60950-1, AS / NZS 60950-1, CB Scheme, EN 60950-1
Certification	FCC Class B ICES class B AS / NZS CISPR22 Class B AS / NZS CISPR22 Class B VCCI Class B EN 55022 Class B, EN 300386
Mounting type	Rack mounting
Internal memory	1024 MB
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	1100 g
Dimensions (WxDxH)	216 x 147 x 36 mm