Juniper SRX1600 - Environmental Requirements and Specifications for SRX1600

Table 23: Site Electrical Wiring Guidelines
Site Wiring Factor Guidelines
Signaling limitaons If your site experiences any of the following problems, consult experts in
electrical surge suppression and shielding:
• Improperly installed wires cause radio frequency interference (RFI).
• Damage from lightning strikes occurs when wires exceed recommended
distances or pass between buildings.
• Electromagnec pulses (EMPs) caused by lightning can damage
unshielded conductors and electronic devices.
Radio frequency interference To reduce or eliminate RFI from your site wiring, you can:
• Use a twisted-pair cable with a good distribuon of grounding
conductors.
• If you must exceed the recommended distances, use a high-quality
twisted-pair cable with one ground conductor for each data signal when
applicable.
Electromagnec compability If your site is suscepble to problems with electromagnec compability
(EMC), parcularly from lightning or radio transmiers, seek expert advice.
Strong sources of electromagnec interference (EMI) may cause the
following problems:
• Destrucon of the signal drivers and receivers in the device
• Equipment damage due to power surge in electrical lines
Environmental Requirements and Specicaons for SRX1600
The SRX1600 must be housed in dry, clean, well-venlated, and temperature-controlled environment.
Follow these environmental guidelines:
• Ensure that the site is dust free because dust can clog air intake vent. This reduces the eciency of
the cooling system.
35