Juniper SRX1600 - Unpack an SRX1600; Verify Parts Received with the SRX1600

• Phillips (+) screwdriver, number 2
• A box cuer or packing knife to slice open the tape that seals the boxes
Unpack an SRX1600
We ship the SRX1600 in a cardboard carton and secure it with foam packing material.
NOTE: The SRX1600 has maximum protecon inside the cardboard carton. Do not unpack it
unl you are ready to begin installaon.
To unpack the SRX1600:
1. Move the cardboard carton to a staging area as close to the installaon site as possible. Make sure
that you have enough room to remove the components from the chassis.
2. Posion the cardboard carton with the arrows poinng up.
3. Carefully open the top of the cardboard carton.
4. Remove the foam covering the top of the SRX1600.
5. Verify the parts received against the list in Table 28 on page 45 .
6. Store the brackets and bolts inside the accessory box.
7. Save the shipping carton and packing materials in case you need to move or ship the appliance at a
later me.
Verify Parts Received with the SRX1600
The shipment includes a packing list. Check the parts you receive in the shipping carton against the
items on the packing list. We ship the parts as per the conguraon that you order.
If any part on the packing list is missing, contact your customer service representave or contact Juniper
customer care from within the U.S. or Canada by telephone at 1-888-314-5822. For internaonal-dial or
direct-dial opons in countries without toll-free numbers, see hps://www.juniper.net/support/
requesng-support.html.
44