Juniper SRX1600 - Factory-Default Configuration of the SRX1600

4. Commit the conguraon to acvate it on the device.
[edit]
root@# commit
5. Congure the IP address and prex length for the Ethernet management interface on the device.
[edit]
root@# set interfaces fxp0 unit 0 family inet address address/prefix-length
6. Congure the default route.
[edit]
root@# set routing-options static route 0.0.0.0/0 next-hop gateway
7. Enable Web access to launch J-Web.
[edit]
root@# set system services web-management http
8. Commit the conguraon changes.
[edit]
root@# commit
Factory-Default Conguraon of the SRX1600
Your rewall comes congured with a factory-default conguraon. The default conguraon includes
the following security conguraon:
• Two security zones are created: trust and untrust.
• A security policy is created that permits outbound trac from the trust zone to the untrust zone.
• Source Network Address Translaon (NAT) is congured on the trust zone.
If the current acve conguraon fails, you can use the load factory-default command to revert to the
factory-default conguraon.
68