Juniper SRX1600 - Connect the SRX1600 to Power; Connect Earth Ground to the SRX1600

Connect the SRX1600 to Power
SUMMARY
Connecng power to the SRX1600 involves
numerous steps and safety precauons to prevent
equipment damage and personal injury.
IN THIS SECTION
Connect Earth Ground to the SRX1600 | 55
Connect AC Power to the SRX1600 | 57
Connect DC Power to the SRX1600 | 59
Power O the SRX1600 | 61
NOTE: To meet the safety and electromagnec interference (EMI) requirements and to ensure
proper operaon, you must connect the SRX1600 to an earth ground before you connect it to
power.
Connect Earth Ground to the SRX1600
NOTE: Before you connect an earth ground to the protecve earthing terminal of the SRX1600,
ensure that a licensed electrician aaches an appropriate grounding terminal to the grounding
cable you supply. Using a grounding cable with an incorrectly aached terminal can damage the
device.
Before connecng the device to an earth ground, ensure that you have the following parts and tools:
• An electrostac discharge (ESD) grounding strap.
• 2-hole protecve earthing terminal.
• Grounding cable for your device—The grounding cable must be 6 AWG (4.11 mm²) stranded wire and
rated 90 °C or per local electrical code.
• Grounding 2-hole terminal for your grounding cable—This aaches to the chassis grounding point
located on the rear of the device.
• A Phillips screwdriver to ghten the screw.
55