Keithley 6485 User Manual

Model 6485 Picoammeter Instruction Manual SCPI Reference Tables 14-11
:DIRection <name> Enable (SOURce) or disable (ACCeptor)
bypass.
ACCeptor √
:DIRection? Query trigger source bypass. √
[:ASYNchronous] Configure input/output triggers:
:ILINe <NRf> Select input trigger line; 1, 2, 3, 4, 5, or 6. 1
:ILINe? Query input trigger line.
:OLINe <NRf> Select output trigger line; 1, 2, 3, 4, 5, or 6. 2
:OLINe? Query output trigger line.
:OUTPut <name> Output trigger after measurement (SENSe) or
not at all (NONE).
NONE
:OUTPut? Query output trigger status.
Table 14-8 (continued)
TRIGger command summary
Command Description
Default
parameter
Ref
Section
SCPI

Keithley 6485 Specifications

General

Model	Keithley 6485
Category	Picoammeter
Input Impedance	>10^14 Ohms
Voltage Burden	<200µV
Accuracy	0.4% of reading
Voltage Source Range	Not Applicable
Voltage Source Resolution	Not Applicable
Voltage Source Accuracy	Not Applicable
Interface	IEEE-488
Power Requirements	100V to 240V AC, 50/60Hz
Dimensions	89 mm high x 214 mm wide x 369 mm deep (3.5 in x 8.4 in x 14.5 in)