4 Remote Interface Reference
252 Keysight 33210A User’s Guide
– When power is turned off, the function generator automatically stores its state
in storage location “0”. You can configure the function generator to
automatically recall the power-down state when power is restored. See the
MEM:STAT:REC:AUTO command on page 254 for more information.
– The front-panel display state (DISP command) is saved when you store the
instrument state. When you recall the instrument state, the front-panel display
will return to the previous state.
– An instrument reset (*RST command) does not affect the configurations stored
in memory. Once a state is stored, it remains until it is overwritten or
specifically deleted.
*RCL {0|1|2|3|4}
Recall the instrument state stored in the specified non-volatile storage location.
You cannot recall the instrument state from a storage location that is empty.
– When shipped from the factory, storage locations “1” through “4” are empty
(location “0” has the power-on state).
–From the remote interface only, you can use location “0” to store a
fifth instrument state (you cannot store to this location from the front panel).
However, keep in mind that location “0” is automatically overwritten when
power is cycled (the instrument state previously stored will be overwritten).
To Next Page
Loading...
