Remote Interface Reference 4
Keysight 33210A User’s Guide 253
MEMory:STATe:NAME {0|1|2|3|4} [,<name>]
MEMory:STATe:NAME? {0|1|2|3|4}
Assign a custom name to the specified storage location. You can name a location
from the front panel or over the remote interface, but you can only recall a state
by name from the front panel (the *RCL command requires a numeric parameter).
The :NAME? query returns a quoted string containing the name currently assigned
to the specified storage location. If you have not assigned a user-defined name to
the specified location, the default name is returned (“AUTO_RECALL”, “STATE_1”,
“STATE_2”, “STATE_3”, or “STATE_4”).
– The name can contain up to 12 characters. The first character must be a letter
(A-Z), but the remaining characters can be letters, numbers (0-9), or the
underscore character (“ _ ”). Blank spaces are not allowed. An error is
generated if you specify a name with more than 12 characters. An example is
shown below.
MEM:STATE:NAME 1,TEST_WFORM_1
– From the front panel, you cannot assign a custom name to storage location
“0”.
– If you do not specify a name (note that the name parameter is optional), the
default name is assigned to that state. This provides a way to clear a name
(however, the stored state is not deleted).
– The function generator will not prevent you from assigning the same name to
different storage locations. For example, you can assign the same name to
locations “1” and “2”.
MEMory:STATe:DELete {0|1|2|3|4}
Delete the contents of the specified storage location. If you have assigned a
user-defined name to a location (MEM:STAT:NAME command), this command also
removes the name that you assigned and restores the
default name
(“AUTO_RECALL”, “STATE_1”, “STATE_2”, etc.). Note that
you cannot recall
the
instrument state from a storage location that is empty. An error is generated if you
attempt to recall a deleted state.
To Next Page
Loading...
