Keysight Technologies 33210A - Page 301

Error Messages 5
Keysight 33210A User’s Guide 301
-221
Settings conflict;
frequency reduced for ramp function
For ramp waveforms, the output frequency is limited to 100 kHz. When you
change to the ramp function (APPL:RAMP or FUNC:RAMP command) from a
function that allows a higher frequency, the function generator will automatically
adjust the frequency to 100 kHz.
-221
Settings conflict;
frequency made compatible with burst mode
For an internally-triggered burst, the output frequency is limited to a minimum of
2.001 mHz. The function generator has adjusted the frequency to be compatible
with the current settings.
-221
Settings conflict;
burst turned off by selection of other mode or modulation
The function generator will allow only one modulation, sweep, or burst mode to
be enabled at the same time. When you enable a modulation, sweep, or burst
mode, all other modes are turned off.
-221
Settings conflict;
FM turned off by selection of other mode or modulation
The function generator will allow only one modulation, sweep, or burst mode to
be enabled at the same time. When you enable a modulation, sweep, or burst
mode, all other modes are turned off.
-221
Settings conflict;
AM turned off by selection of other mode or modulation
The function generator will allow only one modulation, sweep, or burst mode to
be enabled at the same time. When you enable a modulation, sweep, or burst
mode, all other modes are turned off.